The print just started for Majoras Mask for Luke! This build will be in red filament, and is projected to take about 6 more hours. I’ll post details and a report once finished! Live feed is available here should you want to check it out!
WOW That came out great! @Ezra’s knife completed!
Wow, the Destiny 2 Knife came out great, no brim and with the supports added, I think it will look great. It looks a little unusual, but when they supports are cut away, I think it will be awesome. Below are the pictures, and video of taking it off the bed, and you can check the timelapse video.
If you’ve gotten bored with timelapse videos – definitely still check this one out. Due to the size, and position on the bed, the camera captures it really well and it looks great!
@Ezra’s whistle complete, and reprint of Destiny Knife started!
Whistle came out great, no brim or supports needed! While it is incredibly tempting, we won’t blow on it to test it until next Saturday! Below are the pictures, and video of taking it off the bed, and you can check the timelapse video.
In addition, we just started the re-print of Ezra’s Destiny knife – supports added, and size increased. (Smart move to print it diagonally!) Live feed here, expected to go until about 7PM!
@Ezra’s Whistle just started printing
The print for Ezra’s whistle just started! You can watch it live here. It currently has an estimated completion time of ~3:30PM today!
Ezra’s Destiny Hunter Knife complete!
We pulled the print off the printer a bit ago – check the video below for details and you can check the timelapse here. See below for pictures of the print as well. It looks great in black, and the lack of brim doesn’t seem to have been an issue! Can you spot any issues in it that could be corrected? @Ezra – if you think you could make some changes to a slice, and would like to reslice an email it to me, we’d be happy to print it again!
@Ezra’s Destiny Knife (in black) is printing!
I’m happy to report that we are now onto @Ezra’s Destiny knife is now printing. Watch it live here!
Gible (more) successful print complete!
I’m happy to report that although not perfect, the second Gible print for @Luke was more successful. As you can see in the photos and video below, the print successfully completed, although there are some flaws. Who can point out the flaws, and what do you think may have caused them? Here is the timelapse link, as well as a link to the FULL recording of the print. Use the videos to sleuth your way to a hypothesis and put it in the comments below!
Gible – Fail early, and try, try again!
Well, I thought I was going to be brave (first video), but I ultimately chickened out and canceled the Gible print. Check the second video below for a look at the print after it failed, and what I found out that was causing the problem. I’m glad I cancelled it, and have it running again. This second try should finish about 7AM, and I’ll check on it in the morning!
@Luke’s Gible is printing!
Luke’s Gible (in gray) was started 30 minutes ago, and is estimated to complete around 3:30AM. Lots of support structure being put down for the first several layers. I’ll post pics and a timelapse link when it finishes! Check here if you want to see it live.
@Eldin’s Destiny 2 Hunter Knife complete!
The print for Eldin’s Destiny 2 Hunter Knife is completed. Here is a pic of it on the print bed. Took it off the bed, and we’ll keep it exactly as it came off for next Saturday’s class. Check out this link for a timelapse of it printing. It looks great!!!
Print on the bed – used the entire X (clap!) axis 
Close-up, detail looks good 
Adult hand sized, pretty good sized! 
The print is done!